ftdi_sio ttyUSB0: Unable to read latency timer: -110 ftdi_sio 1-3.4:1.0: FTDI USB Serial Device converter detected usb 1-3.4: SerialNumber: 0001Īt first after performing the above the /dev/ttyUSB0 did appear, however on closer inspection of dmesg reveals that ftdi_sio is having problems initializing. usb 1-3.4: Product: CP2102 USB to UART Bridge Controller usb 1-3.4: New USB device strings: Mfr=1, Product=2, SerialNumber=3 In my case my vendor and product id were 10c4 and ea60 respectively ( dmesg told me so) usb 1-3.4: New USB device found, idVendor=10c4, idProduct=ea60 CP210x UART Bridge / myAVR mySmartUSB lightĪfter some searching I found advice that recommended a forceful serial mount by writing the vendor and product id to /sys/bus/usb-serial/drivers/ftdi_sio/new_id. When I first try to establish connection to the serial device I was surprised that Ubuntu did not mount the serial device at all (as in there was no /dev/ttyUSB0), even though lsusb lists the device Bus 001 Device 026: ID 10c4:ea60 Cygnal Integrated Products, Inc. Latest JetPack (version 2.2.1) is installed (4th Sep 2016), which should be running the current latest Ubuntu kernel et al.TX1 is connected to SimpleBGC (Camera Gimbal Controller) via USB to Serial (e.g.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |